VACS:Projects:Hardware:LPS:Box
From VACS
Revision as of 22:30, 14 February 2007 by Stephane.Carrez (Talk | contribs)
This page deals with how the LPS appliance is physically arranged.
Dimensions
Name | Count | Dimension (LxWxH) | Notes |
---|---|---|---|
80VA Toric Transformer | 2 | 94mm x 37mm (Tore) | The toric transformer is heavy: 950g |
Positive/Negative Power Supply Rectifier | 2 | 123mm x 80mm x 50mm | The height of the board is defined by the 22000uF decoupling capacitor. The two boards are stacked together in opposite directions in such a way that the total height does not exceed 70mm. |
LPS Power supply board | 1 | 100mm x 80mm x 50mm | The height of the board is defined by the capacitors and the heat sink. |
Positive/Negative Power Supply Controller | 2 | 100mm x 80mm x 20mm | The board must be a small height to be stacked together with the LPS master,
the total must not exceed 60mm so that the heat sink will fit in the final box. |
LPS Master Controller | 1 | 100mm x 80mm x 20mm | |
Positive/Negative Power Supply Outputs | 2 | 100mm x 80mm x 35mm | These two boards are directly mounted on the heat sink. |
Positive/Negative Voltage Regulator | 2 | 80mm x 38mm x 15mm | The voltage regulator board is plugged (vertically) on the associated power supply output board. |
Fan | 1 | 80mm x 80mm x 25mm | |
LPS LCD Panel | 1 | 92mm x 114mm x 16mm | The display panel has a reduced height due to the buttons and LCD module. |
ATX PC supply | 1 | 145mm x 110mm x 65mm | |
Heat sink | 1 | 155mm x 75mm x 25mm | The heat sink has one part within the box and another external to the board. The dimension
correspond to the internal part only. |
Facade
The LPS box facade contains the plugs for every power supply lines. There are two hot plugs and two ground plugs for each power supply output (16 plugs total). The ATX power supply is available through specific connectors that will deliver a +12V, +5V and +3.3V.