VACS:Projects:Hardware:LPS:Connectors
From VACS
Revision as of 13:59, 18 November 2006 by Stephane.Carrez (Talk | contribs)
This page describes the connectors of the hardware boards.
Rectifier Board
1 | IS11 | MOSFET driver current selector 0.22 ohm (active low) | Power supply 1 | |
2 | IS12 | MOSFET driver current selector 0.66 ohm (active low) | ||
3 | RE1 | Power supply relay selector (active high) | ||
4 | Io1 | Output current measure | ||
5 | -5V | |||
6 | +24V | |||
7 | Io2 | Output current measure | Power supply 2 | |
8 | RE2 | Power supply relay selector (active high) | ||
9 | IS22 | MOSFET driver current selector 0.66 ohm (active low) | ||
10 | IS21 | MOSFET driver current selector 0.22 ohm (active low) |
LCD Panel
1 | GND | ||
2 | VROT | Rotative wheels output voltage | |
3 | VBUTTON | Buttons output voltage | |
4 | LCD_BACKLIGHT | LCD backlight driver (active high) | |
5 | LED_1 | LED supply 1 (active high) | |
6 | LED_2 | LED supply 2 (active high) | |
7 | LED_3 | LED supply 3 (active high) | |
8 | LED_4 | LED supply 4 (active high) | |
9 | LCD_CLK | LCD serial clock | |
10 | LCD_D | LCD serial data | |
11 | LCD_CS | LCD chip select (active low) | |
12 | +5V |