VACS:Projects:Hardware:LPS:Connectors
From VACS
Revision as of 15:30, 26 November 2006 by Stephane.Carrez (Talk | contribs)
This page describes the connectors of the hardware boards.
Rectifier Board
The rectifier board is connected to the power supply microcontroller board for the control and measurement of the output current. For the power distribution it has several one wire high power connectors (not described here).
1 | IS11 | MOSFET driver current selector 0.22 ohm (active low) | Power supply 1 | |
2 | IS12 | MOSFET driver current selector 0.66 ohm (active low) | ||
3 | RE1 | Power supply relay selector (active high) | ||
4 | Io1 | Output current measure | ||
5 | -5V | |||
6 | gndref | Ground reference for current measurement | ||
7 | gndref | Ground reference for current measurement | ||
8 | +24V | |||
9 | Io2 | Output current measure | Power supply 2 | |
10 | RE2 | Power supply relay selector (active high) | ||
11 | IS22 | MOSFET driver current selector 0.66 ohm (active low) | ||
12 | IS21 | MOSFET driver current selector 0.22 ohm (active low) |
LCD Panel
1 | GND | ||
2 | VROT | Rotative wheels output voltage | |
3 | VBUTTON | Buttons output voltage | |
4 | LCD_BACKLIGHT | LCD backlight driver (active high) | |
5 | LED_1 | LED supply 1 (active high) | |
6 | LED_2 | LED supply 2 (active high) | |
7 | LED_3 | LED supply 3 (active high) | |
8 | LED_4 | LED supply 4 (active high) | |
9 | LCD_CLK | LCD serial clock | |
10 | LCD_D | LCD serial data | |
11 | LCD_CS | LCD chip select (active low) | |
12 | +5V |